CommunityRacingSchedulesRace ReportMedia
February 13, 2012
Login   Sign Up
Community > Forums > General Discussion on Drag Boat Racing Interactive > Ask the Tech > Blue printing and speed coating of hulls?
Drag Boat Racing Interactive Forums
Blue printing and speed coating of hulls?
Last Post 25 Jan 2008 04:48 PM by Frank Toftemark. 1 Replies.
AddThis - Bookmarking and Sharing Button Printer Friendly
  •  
  •  
  •  
  •  
  •  
Sort:
PrevPrev NextNext
You are not authorized to post a reply.
Author Messages
Frank Toftemark Rookie Rookie Send Private Message Posts:1 Frank Toftemark
--
25 Jan 2008 04:48 PM
   Hello everyone I am new here ot your forum.  A little about myself I am a sprint boat racer here in the US, I race a 13' aluminum boat with a scotts 81/4" jet pump with a 675 horse sbc. This form of racing is very popular in New Zealand and Australia.   I was wondering what the procedure is of blueprinting and speedcoating the bottom of your hulls.  I was wondering if this type of setup would be helpfull in my application where the boat is making a lot of turns and not a straight line though.  Thank you very much for any of your input and I enjoy watching your sport and will be on the shores ar Red Bluff cheering you guys on.  Thanks again Frank


BAF316PE Send Private Message Posts:557 BAF316PE
--
26 Jan 2008 04:07 AM

You need to go to the following site

 

 http://www.performanceboats.com/htm...a8e8f67b8d

under V-Drives

You can get all your roundy round info there

 

guesswho77.jpg
guesswho77.jpg
You are not authorized to post a reply.
Forums > General Discussion on Drag Boat Racing Interactive > Ask the Tech
  Forums | In The Pits    
Copyright 2006-2011 by DBS Inc   ||  Terms Of Use  ||  Privacy Statement